Before reading EGC17C59.
All you need:
KTAG Cable 14P600KT02
16-way rainbow ribbon cable 144300T105
Two 470 Ohm resistors
Solder wire
KTAG Firmware 7.020 read Opel EDC17C59
pinout & wiring diagram
Solder the two 470 Ohm resistors on the
pads as picture:
Solder a wire joining the two pins BOOT and
solder a wire to pin CNF1 as picture:
Use the Cable 14P600KT02 to connect KTAG
with ECU EDC17C59 as picture:
Solder the rainbow ribbon cable 144300T105
to the pads as picture: (Make sure not to make short circuit between the pads)
So connect KTAG 7.020 with Opel EDC17C59
ECU like this:
After that, open K-Suite V2.23 software.
Choose "OPEL"→
"Insignia"→ the right "BOSCH EDC17C59" and click
"OK".
Choose "BOSCH EDC17C59 IROM TC1767
OPEL GPT (P688)".
Click "Read" to read ECU data and
wait it complete 100%!
Tips: KTAG FW7.020 PCB Board for
checking
View more:http://www.eobdtool.co.uk/wholesale/auto-ecu-programmer/
No comments:
Post a Comment